Epever wifi app download

My controller is listed as compatible with the eBox. I even tried resetting the eBox via the reset hole, using a paper clip end, butno change in behavior.

I should really return it, but will try some Internetsearches first. Jonathan Robert Gonzalez — January 28, Cornellia K. Just got this in today. UPS got it to me a day early! It hooked right up and worked without issue.

All functions seem to work at the same time. It is logging, monitoring, and driving the MT, all without issue. I will update this as time goes on. My current solar output is low.

But its cloudy, and pm. Verified Customer — February 23, EPever limited themselves here, they should have allowed this, they would sell more of them. Unbricking is not for the timid. Works with my iPhone. Drops connectivity regularly, every 5 minutes or so. Then you have to try various tricks to reconnect. I would like to trade for the Bluetooth version. MarcusMarcus — March 15, I have contacted support but they are completely unhelpful. They tell me it does not have STA mode even though there is clearly shows STA settings and say it can only connect through the app even though I am connected through the web browser.

I cannot figure why they would cripple this device. What is the point of a wifi adapter if it cannot connect to an existing wifi? Why would I need to have it have its own wifi that I manually have to connect to causing loss of Internet connection just to read info from it? Then have to manually switch wifi connection back to standard wifi so I can get wifi again, but loss connection to the ebox?

Then I have to forget the wifi connection to the ebox, because it would occasionally connect to it, causing me to loose Internet. They seem to have put little to no thought into this device.

Lewie — March 19, It works… getting files is a bit … manual. Make sure you click in the following order: Open, Query, Download, Close. The software leaves much to be desired — but as I said, it works.

Set your time immediately! Pros: You can still use compatible accessories in addition to this one at the same time. Manual is in English. The charts are incremented as long as the monitoring is active, and you might want to clear the charts once in a while. You can do so by right-clicking on the chart, then select Clear. In the left column, you have some key numbers of how much power your solar setup has generated; daily, monthly, annual, and in total. You also have the same numbers for power consumption through the controller load.

The voltage chart shows the voltage development over time for both the solar panel, the battery, and the load. For some unknown reason, the battery curve does not show up in our setup. The current chart shows the Amperage curves for the solar panel, the battery the current going from the controller and into the battery , and the load. The power chart is the most useful, in our opinion. It shows the wattage development for the solar panel and the load. Here, you get an impression of how well your solar panel setup is performing.

In our setup, we use a W panel, but it's rear to have the wattage above W. It's possible to do some tweaking of the settings on the charge controller with the solar station monitor as well.

Before you can change anything, you have to fetch the current settings from your charge controller. You must be logged in to post a review. Remote Temperature Sensor. Communication USB Cable. MT50 Remote Meter Monitor. Note: If you do not receive a notification email, please check the spam box. Remember me Log in. Lost your password? Subscribe to our newsletter.